| No. | Project | Technical parameters |
| 1 | Overall dimension (L*W*H) | L30000* W14500* H3000mm |
| 2 | The floor is load-bearing (T/m²) | 2T |
| 3 | Electric control cabinet size （mm） | 400*200*2000mm800*200*2000mm |
| 4 | Power source | 380V+N+PE, 50/60Hz |
| 5 | Maximum power consumption KW | 106.1Kw |
| 6 | Air source specification | Air consumption：800-1000 L/minAir pressure： 0.6-0.8 MPa |
| 7 | Tap water usage （L/min) | 1.5 |
| 8 | Dust collection air volume m³/min | 8 |
| 9 | Applicable steel board size mm | 787mm (L)* 1295 mm (W)* 1.6 mm(H) |
| 10 | Copper foil roll width mm | 1295mm |
| 11 | Copper foil thickness | 1/3~3ounces |
| 12 | Automatic combination table | 11 set |
| 13 | Time to fold 1 sandwich (copper foil+steel board+copper foil) | ≤13s |
| 14 | Base board switch time | ≤35s |
| 15 | Copper foil cutting mode | The upper and lower copper foils are cut in one piece |
| 16 | Stacking accuracy | ±1.5mm |
| 17 | Steel board alignment accuracy | ±1mm |
| 18 | Copper wrinkle rate | The copper wrinkle rate of the PCB board below 16 layers is controlled to be less than or equal to 0.2 %The copper wrinkle rate of 18-32 layers of PCB boards is controlled to be less than or equal to 0.3% |
| 19 | Automatic dismantling table | 1 set |
| 20 | Steel board grinding method | Double-sided wet belt sander |
| 21 | Steel board cleaning method | Steel board cleaning machine (2-brush) |
| 22 | Grinding and cleaning line speed | 0-30 m/min |
| 23 | Empty chassis is temporarily stored | Temporary storage rack (12 layers) |
